Gas Fitter Metford
Metford Plumbing Co is the licensed gas fitting team for Metford, connecting appliances, tracing gas leaks and repairing gas lines for homes from the station streets to the newer pockets, and out through the wider Maitland council area. You approve the price for each gas job before a spanner turns, and every connection is leak-tested before we leave.
Licensed plumbers and gas fitters · NSW Lic. 359278C
Last updated September 2026
- Available 24/7
- No call-out fee (excluding after-hours)
- Fixed, up-front quotes
- 365-day warranty on all work
What Gas Work Does a Metford Home Need?
Most gas work falls into a few clear groups, and each one is licensed work by law:
- Appliance connections: cooktops, wall ovens, space heaters, outdoor BBQs and pool heating, each commissioned and tested.
- Gas bayonet points: new points fitted, old points checked or capped off.
- Leak tracing with gas detectors, down to the exact joint, then the repair.
- Gas line repairs: corroded or damaged sections replaced and pressure-tested.
- Gas hot water, including repairs, swaps and new installs, covered in detail on the hot water hub.
Any job touching gas is licensed work, and the licence is the legal line between a safe connection and an untested one.
Metford Gas Fitting Services
Each of the two services below has its own page and method:
Gas Appliance Installation
New cooktops, ovens and heaters, plus BBQ and pool heater points, fitted and leak-tested. The install steps are laid out under gas appliance installation.
Gas Leak Detection
Smells, hissing lines, unexplained gas usage and pressure faults traced with detectors and repaired on the spot. Read gas leak detection for what to do before you ring.
How Do You Know the Gas Needs Attention?
Gas faults give warning, and each sign points at a different problem:
- A sulphur-like smell, which is the odourant added to natural gas so leaks announce themselves.
- Cooktop burners showing lazy yellow tips instead of a clean blue flame, which means incomplete combustion.
- Hissing near a meter or line, or unexplained jumps in the gas bill.
- Heaters that shut down or smell sharp when running, which usually points to the unit rather than the line.
For a strong gas smell the order never changes: people out first, no switches or flames, the gas network's emergency number rung from the footpath, and then a call to us. Never hunt for a gas leak with a flame or a light switch.
How Gas Jobs Are Priced Here
We provide up-front, honest quotes that will always match the final price, should you decide to go ahead.
With gas, the test is part of the quote, so a connection never grows a testing bill afterwards. What changes the figure:
- The appliance type, because a cooktop connection and a pool heater run are different days of work.
- The line length, since a new bayonet far from the meter means more pipe and more time.
- Access to the existing line, which in brick-veneer homes can mean working through ceilings or under floors.
- After-hours timing, which carries its own rate and is quoted before anything starts.
Why Gas Fittings Here Age Fast
The build wave left its mark
Those joints are now decades old
Cool Hunter Valley winters keep gas working hard
What Happens When You Call
- 01
Ring or send the form
Call (02) 4915 2998 or use the form to explain the fault. We ask enough to bring the right equipment the first time.
- 02
A fixed price first
A plumber inspects the job and names a fixed figure up front. Nothing gets started until you give the go-ahead.
- 03
Connect, test, sign off
The appliance or line is fitted or repaired, then pressure and leak tests confirm the whole run is sound before anything gets signed off.
- 04
Covered for a year
Every job carries our 365-day warranty on all work. If something we did isn't right, ring the same number.
What Customers Say
We had an urgent gas problem that required immediate attention at our home…on a Friday afternoon. … Identified the issue, fixed and tested
When We're Not the Right Call
Low pressure from the street main is a gas network fault, so it goes to them rather than to us. Everything on the house side of the meter, including the lines, bayonets and appliances, is ours.
Frequently Asked Questions
Do you install gas heaters and bayonets in Metford homes?
Yes. Heater connections, new bayonet points and appliance swaps are all licensed gas work, and you see the price before the first fitting comes out. Homes on the 1990s and 2000s streets here often have original bayonets worth checking before a new heater goes on them.
Can a gas fitter connect a BBQ or a pool heater?
Both. Outdoor BBQ points, pool heaters, ovens and cooktops all need licensed hands for the connection and the leak test, because an untested joint is the one that catches nobody's attention until there is a problem.
Is a gas smell something I should wait on?
No. Clear the house, leave light switches and anything burning alone, and call the gas network's emergency line from the street before you ring us. A suspected leak gets handled as urgent whatever the hour.
Do you also work on gas hot water systems?
Yes, gas hot water sits under the same licence. Whether to fix or replace, and which system to choose, is set out under hot water, so one plumber handles the diagnosis once rather than the fault getting explained twice by two trades.
Need a plumber? Call or send the form
Call (02) 4915 2998 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.
Request a callback
Leave a name and number and a plumber will ring you back.